Главная 7 Aquarium 7 How to make a filter for an aquarium

How to make a filter for an aquarium

maintenance, care, compatibility

Each aquarium should have a filtration system that will purify the water, ensuring the health of the fish and plants. As it is known, wastes that are left behind by the inhabitants of the reservoir, as well as the remnants of food, suspended particles of soil are very harmful for fish.

Not eaten feed is oxidized, turning into toxic ammonia. In order for the water to pass through all the steps of cleaning in a timely manner, it is better to make an external filter for the aquarium with your own hands.

It will prevent the appearance of harmful substances that can poison living beings.

The self-made external filter is constructed on the basis of aerolifting: air bubbles that come from the compressor, rise to the tube, from which they come to the top, and lower with them the water flow from the filter. Clean and oxygenated water enters the upper compartment of the glass, and passes through the gravel. Then the water enters the bowl through the hole, goes down the tube, and enters the tank.

Synthon here functions as a mechanical filter. This material prevents the silting of the gravel substrate.

External filters chemically and mechanically purify water. It is better to install such structures in a large aquarium with a volume of 200-400 liters.

For more spacious aquariums with a capacity of 500-1000 liters will need several such devices. Branded external water treatment systems are expensive, so it’s best to do it yourself.

Materials are inexpensive and accessible to everyone.



Filter for aquarium do it yourself :: DIY aquarium filters :: Household :: Other

External filter for aquarium makes chemical and mechanical water purification. Typically, this type filters installed on aquariums with a volume of 200 liters.

Very large aquariums may require several filterov These devices belong to a high price category, so you can try to make such filter do it yourself

1. Pick for enclosure filterand a cylindrical piece of plastic. For these purposes, a piece of plastic sewer pipe is suitable.

The length of the pipe fragment must be at least half a meter. The hull will require plastic parts that play the role of cover and bottom. Make a hole in the bottom of the case.

Screw the fitting into this hole. You can buy it ready or take it from another device, for example, from the sensor from the heating boiler of the bus.

Then you will need FUM tape to seal the thread. Wind it onto the threads of the fitting.

Lock the fitting with the enclosed nut inside the housing. filterbut.

2. Cut a circle out of plastic. Using a drill or a knife, make a lot of medium-sized holes in it. Put a circle on the bottom filterbut.

Thanks to him, the bottom hole filterand will not be very clogged.

3. Getting Started filterOur filler. Put a round piece of foam rubber on top of the plastic circle.

On top of the foam rubber, pour in a special filler for filterWater rations, which can be bought at a pet store. It is made of ceramic material. Repeat layers again.

First foam and then ceramic biofilter.

4. Over filterLayers installed electric pump. It will create the movement of water from the bottom up.

For a wire with a switch that goes from the pump, make a hole in the plastic case. Insulate the hole sealant.

5. Prepare two tubes. They may be plastic. With the help of them will be the flow of water in filter and its exit back to the aquarium.

Connect one tube to the bottom outlet. To the bottom of the tube you need to connect a special faucet that will remove air from the external filterbut.

Connect another tube to the top cover. filterand to the fitting. Immerse the tubes in the aquarium.

Now you can turn on the finished external filter and check it out in action.

How to make an external filter for the aquarium :: how to make a pump for sewage itself :: Equipment and accessories

External filter for aquarium makes chemical and mechanical water purification. Typically, this type filters installed on aquariums with a volume of 200 liters.

Very large aquariums may require several filterov These devices belong to a high price category, so you can try to make such filter do it yourself

1. Pick for enclosure filterand a cylindrical piece of plastic. For these purposes, a piece of plastic sewer pipe is suitable. The length of the pipe fragment must be at least half a meter.

The hull will require plastic parts that play the role of cover and bottom. Make a hole in the bottom of the case.

Screw the fitting into this hole. You can buy it ready or take it from another device, for example, from the sensor from the heating boiler of the bus. Then you will need FUM tape to seal the thread.

Wind it onto the threads of the fitting. Lock the fitting with the enclosed nut inside the housing. filterbut.

2. Cut a circle out of plastic. Using a drill or a knife, make a lot of medium-sized holes in it.

Put a circle on the bottom filterbut. Thanks to him, the bottom hole filterand will not be very clogged.

3. Getting Started filterOur filler. Put a round piece of foam rubber on top of the plastic circle. On top of the foam rubber, pour in a special filler for filterWater rations, which can be bought at a pet store.

It is made of ceramic material. Repeat layers again.

First foam and then ceramic biofilter.

4. Over filterLayers installed electric pump. It will create the movement of water from the bottom up. For a wire with a switch that goes from the pump, make a hole in the plastic case.

Insulate the hole sealant.

5. Prepare two tubes. They may be plastic. With the help of them will be the flow of water in filter and its exit back to the aquarium.

Connect one tube to the bottom outlet. To the bottom of the tube you need to connect a special faucet that will remove air from the external filterbut.

Connect another tube to the top cover. filterand to the fitting. Immerse the tubes in the aquarium.

Now you can turn on the finished external filter and check it out in action.

О admin

x

Check Also

Equipment for the aquarium – 1 part

In recent years, the quantity and range of aquarium equipment, commercially available, grew exponentially. Therefore, ...

Aquarium Decoration – Terraces

Terraces in the Aquarium Aquarium terraces are one of the popular decorative elements. The terrace ...

Equipment for the aquarium – part 2

Aquarium water treatment equipment This equipment is used to pump air through the water of ...

Nano-aquarium – arrangement, launch, maintenance

Fashionable now the prefix “nano” is now used in aquarism. And not just used, but ...

Aquarium decoration

We have already discussed in the previous article how important it is to properly understand ...

Design elements of the aquarium – Stones, Shells, Snags

In most cases, the general aquarium contains fish originating from the natural environment, where rocks ...

Frozen feed – nutrition and benefits

Many aquarium fish can only eat dry food, but even for them regular inclusion in ...

Reproduction of aquarium plants – Types and methods

Plants in an aquarium not only give it a unique look and personality, but also ...

Water for aquarium – chemical indicators – hardness, PH

There is every reason to believe that aquarium water is the most important part of ...

Aquarium where to start – what kind of fish to get

You have decided to become an aquarist, or at least dream about it. You may ...

Fish diseases – diagnosis and definition

The articles describe the following diseases, their signs and methods of treatment: alkalosis (alkaline disease), ...

Aquarium in the interior – the choice of aquarium and fish

The aquarium is an amazing decorative element in a modern interior, it adds uniqueness and ...

Aquarium Heater

Heater or heater for aquarium For the normal functioning of the ecosystem of the aquarium ...

Frequently asked questions about aquarism – part 1

Hello, friends! Starting today, I am launching a new category – frequent aquarium questions. In ...

Frequently asked questions about aquarism – Part 3

Hello, dear readers. We continue to fill in the “Aquarium Habit” rubric and I have ...

Frequently asked questions about aquarism: light and temperature

Good day, dear readers! We continue to get acquainted with the Frequently Asked Questions section ...

Algae in the aquarium and what may be due to their problems

Hello dear colleagues, I am glad to welcome you again on my blog reading articles ...

How is the catch of aquarium fish in the Amazon

Good day, dear readers! Today we will not talk about aquarium fish, plants and other ...

Frequently asked questions: part 7

We continue to study the topic of frequently asked questions from novice aquarists, and today ...

Aquarium fish as a barometer for a fisherman

An experienced fisherman always remembers the truths associated with fishing. Pros of the business – ...

How to make an aquarium with silicate glass

I welcome you, dear readers on the pages of the blog aqua-blog.com.ua and as you ...

How to feed aquarium fish – frequently asked questions №4

Hello colleagues. We continue to deal with the most frequently asked questions about aquarism. Today ...

Algae in the pond: prevention and how to get rid of them

Good day, dear colleagues. In today’s article I would like to touch upon the topic ...

New technologies in modern aquarism

Hello, friends! Today I do not want to write about any plants, fish and so ...